LNEYA工業用冷凍機 メーカー サプライヤー
ニュース
液冷バッテリーパック AMS冷却システム紹介
The LNEYA liquid-cooled battery pack AMS cooling system can be applied in many scenarios in the new energy material industry. In the midstream industry of new energy raw materials, the purification of raw materials, the process temperature control of production, the cooling cycle system of grinding equipment, and the downstream industry In many scenarios, such as the cooling system of the special test box for new energy electronic components, and the liquid-cooled low-temperature test of ...
詳細を見る電源管理チップ温度試験システムを購入するには？
The power management chip temperature test system is an important equipment used to test the performance and reliability of semiconductor chips in different temperature environments. When purchasing this type of test equipment, you need to consider the following points: In short, when purchasing a power management chip temperature test system, you need to consider the above points comprehensively to ensure that the purchased equipment can meet the testing need...
詳細を見る液体流通システム用冷却・加熱温度制御装置
The cooling and heating temperature control equipment of the liquid distribution system is a dynamic temperature control system produced by LNEYA. When we purchase the cooling and heating temperature control system of the liquid distribution system, we need to pay attention to low temperature, capacity, power factor, and after-sales service. Submit for consultation We will reply to you within 24 hours * * Email: sales@cnzlj.com...
詳細を見る化学反応におけるジャケット付きリアクター冷却・加熱システムの応用
In the chemical industry, jacketed reactor cooling and heating devices are widely used in various chemical reactions. Application of jacketed reactor cooling and heating devices in various chemical reactions： Polymerization is a common chemical reaction that usually requires higher temperature and pressure conditions. The use of a jacketed reactor hot and cold integrated mold temperature controller can better control the temperature and pressure and improve the efficiency and...
詳細を見るフッ素系液体TCU温度制御システムのメンテナンス原理
Fluorinated liquid TCU temperature control system should be placed in a ventilated, dry and clean place; (2) The distance between the fluorinated liquid TCU temperature control system and the partition is greater than 1m; (3) The louver holes on both sides of the fluorinated liquid TCU temperature control system must not be obstructed or blocked 3. If the fluorinated liquid TCU temperature control system has been used for more than six months, or the high/low pressure s...
詳細を見るSemiconductor production process and testing process temperature control unit
LNEYA semiconductor testing process chiller
詳細を見るWhat is the local overheating machine room water chiller?
What is the local overheating machine room water chiller?
詳細を見る
